GEN III Circulator
Designed for practice, qualifying, and race conditions the Generation III Water Circulator efficiently cools hot race engines and removes air trapped in the system; allowing more runs per session. Optional heater available.
PART NUMBERS:
CR-NC-BOA001A………. 3rd Generation Water Circulator (with heater)
CR-NC-BOA002A………. 3rd Generation Water Circulator
- Heavy duty front casters
- Recessed control panels
- Stainless steel pump (increased flow rate 20% – 10 psi added at pump exit)
- Dump valve
- Float valve
- Filter to “catch” small pebbles, silicone, etc. – minimal flow loss
- Heater control valve
- 30 gallon tank capacity
Specifications
|
AMP Requirements (220V)
|
|
| Pump: | 3.6 amps |
| Fan: | 1.7 amps |
| Heather: | 16.3 amp |
|
Flow Rates (flowmeter located at radiator exit -without engine and water pump)
|
|
| 25 ft lines: | 10.3 gpm (will pump 5 gallons in 15.23 sec — exit of one 25 ft line) |
| GEN II : | 8.5 gpm (will pump 5 gallons in 18.66 sec — exit of one 25 ft line) |
| 40 ft lines : | 9.8 gpm (will pump 5 gallons in 16.89 sec — exit of one 40 ft line) |
| GEN II : | 7.9 gpm (will pump 5 gallons in 20.57 sec — exit of one 40 ft line) |
|
Heat Cycles (diverter valve on “RAD ONLY” – control valve switched to “HEAT”)
|
||
|
Time (minutes)
|
GEN III Temp (Degrees F)
|
GEN II Temp (Degrees F)
|
|
0
|
78
|
80
|
|
5
|
91
|
87
|
|
10
|
107
|
94
|
|
15
|
113
|
97
|
|
20
|
119
|
103
|
|
25
|
124
|
107
|
|
30
|
128
|
112
|
(diverter valve on “RAD ONLY” — control valve switched to “HEAT”)
Downloads: